Superior integration of hydraulics and electronics
Energy saving hybrid drive, low Co2 emissions
Only 22 litre oil tank
Low noise
User friendly touch screen control
Return-to-Sender sheet support
Torsion free cutting of small strips
Scrap separation
Fully automatic adjustment of cutting angle and clearance
With the M-Shear, the blade cuts four ways
The robust hydraulic systems in the SafanDarley M-Shear are controlled by modern electronics. This means that the regulatory mechanism has evolved from hydraulic to electronic technology. A successful E-volution that increases both your productivity and the quality of your products.
The standard equipment for the SafanDarley M-Shear includes blades with four cutting edges, on both the top and bottom. Your shearing is done very economically because blade wear is spread over the blade’s entire length, thanks to the programmable starting position of the cutting beam.
The servo-electronic motor powering the hybrid drive only runs when the cutting beam is in motion. This yields two advantages: energy savings and the cutting cycle produces low noise levels. In combination with the solid construction and the modular assembly, makes this M-Shear a superior guillotine shear.
Standard Specification
Touch Screen control, type TS200 with TFT colour monitor on a swivel arm
CNC controlled backgauge
Automatic clearance and cutting-angle adjustment
Automatic retraction of the backgauge for narrow strip widths
Adjustable starting and end stopping position for the entire length of the cutting beam
Backgauge supports equipped with ball screws and play free linear guides
Maintenance free cutting beam guides
Fine adjustment of backgauge parallelism
Adjustable hold down cylinders
Push-on adiprene covers for the hold down cylinders
Blades with 4 cutting edges, suitable for shearing stainless steel (max. tensile strength 54,4 US ton per square inch)
Cutting line lighting with cutting line indication
2 support arms, adjustable over the entire width of the table (length is approx. 47,24 inches from the cutting line)
2 squaring guides on the right and left sides of the table (across the entire table width)
2 rulers in the table
T slots and hand slots spread across the width of the table
1 T slot on the front of the table
2 spring-action stops
Key switch (3 positions)
Safety features complying with the European Machine Directive
